Maintenance - Chicago Electric 68829 Owner's Manual & Safety Instructions

Maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical outlet
before performing any inspection, maintenance, or cleaning procedures.
TO pREVENT SERIOUS INJURy FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1. BEFORE EAcH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may
affect its safe operation.
Page 12 For technical questions, please call 1-800-444-3353.
2. AFTER USE, wipe external surfaces of the
tool with clean cloth. Remove cut-off pieces
and scraps from Table:
a. Switch off and unplug tool.
b. Once Blade stops completely, remove Blade
following instructions on page 11.
c. Remove all debris.
d. With a brush, cloth, or vacuum, remove
sawdust from Table Saw. Allowing
sawdust or other debris to accumulate
can cause a fire, resulting in severe
personal injury or property damage.
3. WARNING! If the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
Item 68829