Siemens SIMATIC Box PC 840 Manual page 90

Configuring the SIMATIC Box PC 840
"Boot Options" Field
The following submenu appears when you select the "Boot Options" field in the
main menu:
Main
QuickBoot Mode:
SETUP prompt:
POST Errors:
Floppy check:
Summary screen:
F1 Help
ESC Exit
Figure 5-4 "Boot Options" Submenu
Quick Boot
Mode
SETUP prompt
POST Errors
Floppy check
Summary
screen
'Enabled' means that the feature is active. 'Disabled' means that the feature is
inactive.
5-8
PhoenixBIOS Setup-Utility
Boot Options
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
Select Item + / – Change Values
Select Menu Enter Select
Some hardware tests are skipped to speed up the boot procedure.
The message PRESS <F2> to enter Setup appears at the bottom of the
screen during the system run-up phase.
The boot process is stopped if an error is detected; you must press F1 to
acknowledge. Enter "Disabled" to avoid the necessity of acknowledging
errors, for example, if no keyboard is connected.
The floppy head is stepped inward and then back to its original position
during the system run-up phase. This test is useful because it
reinitializes the drive.
The most important system parameters are displayed when the system
run-up phase completes.
Item Specific Help
Allows the system to skip
certain tests while booting.
This will decrease the time
needed to boot the system.
F9 Setup Defaults
Sub-Menu F10 Save and Exit
SIMATIC Box PC 840 Manual
A5E00085984-04