Table of Contents
Advertisement
Chapter 2
Installing the Access Point
Note
•
•
Figure 2-24
FROM AC/DC ADAPTER
REMOVE IEC PLUG
Configuring the Access Point
For information on configuring the access point, see the following documents:
•
•
•
OL-32138-01
Cut and remove the AC plugs from each cable. Cut just past strain relief to be sure that the cable is
not cut too short.
Ensure that the wiring splice is properly secured and protected.
Wiring Streetlight Power Tap Adapter to AC/DC Power Adapter
BROWN (L)
BLUE (N)
GREEN (GND)
For Lightweight Access Points and Mesh Access Points, see the Cisco Wireless LAN Controller
Configuration Guide, which is available at:
http://www.cisco.com/en/US/docs/wireless/controller/7.6/configuration/guide/b_cg76.html
For Mesh Access Points, see the Cisco Wireless Mesh Access Points, Design and Deployment Guide,
which is available at:
http://www.cisco.com/en/US/docs/wireless/technology/mesh/7.6/design/guide/mesh76.html
For Access Points in autonomous mode, see the Cisco Aironet Access Points Configuration Guide
for Cisco IOS Software, which is available at:
http://www.cisco.com/en/US/docs/wireless/access_point/15_2_4_JB/configuration/guide/scg15.2.4
_JB3a_Book.html
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
BLACK (L)
WHITE (N)
GREEN (GND)
Configuring the Access Point
FROM AC STREET LIGHT
TAP REMOVE CIRCULAR
CONNECTOR
2-39
Advertisement
Table of Contents
