Overview - Cisco AIR-AP1572IC Hardware Installation Manual

Overview

Overview
This section contains a DHCP Option 43 configuration example on a DHCP server for use with Cisco
Aironet Access Points. For other DHCP server implementations, consult DHCP server product
documentation for configuring DHCP Option 43. In Option 43, use the IP address of the controller
management interface.
Note DHCP Option 43 is limited to one access point type per DHCP pool. You must configure a separate
DHCP pool for each access point type.
Cisco Aironet 1000, 1500, 1532 access points use a comma-separated string format for DHCP Option
43. Other Cisco Aironet access points use the type-length-value (TLV) format for DHCP Option 43.
DHCP servers must be programmed to return the option based on the access point DHCP Vendor Class
Identifier (VCI) string (DHCP Option 60). The VCI strings for Cisco access points that can operate in
lightweight mode are listed in
Table F-1
Access Point
Cisco Aironet 1000 series
Cisco Aironet 1100 series
Cisco Aironet 1130 series
Cisco Aironet 1200 series
Cisco Aironet 1240 series
Cisco Aironet 1250 series
Cisco Aironet 1300 series
Cisco Aironet 1500 series
Cisco Aironet 1520 series
Cisco Aironet 1570 series
1. For controller release 4.1 or later.
2. For controller release 4.0, the VCI depends on the model.
3. For controller release 3.2.
The following is the format of the TLV block for 1100, 1130, 1200, 1240, 1250, 1300, 1520, and 1532
access points:
•
•
•
Cisco Aironet 1570 Series Outdoor Access Point Hardware Installation Guide
F-2
Lightweight Access Point VCI Strings
Type: 0xf1 (decimal 241)
Length: Number of controller IP addresses * 4
Value: List of WLC management interfaces
Table F-1.
Vendor Class Identifier (VCI)
Airespace.AP1200
Cisco AP c1100
Cisco AP c1130
Cisco AP c1200
Cisco AP c1240
Cisco AP c1250
Cisco AP c1300
Cisco AP c1500
Cisco AP.OAP1500
Cisco AP.LAP1505
Airespace.AP1200
Cisco AP c1520
Cisco AP c1570
Appendix F Configuring DHCP Option 43
1
2 2
, Cisco AP.LAP1510
2
3
OL-32138-01
, or