Removing And Installing Optional Components; Installing Countertop Wedge; Removing Or Installing The I/O Module - VeriFone MX 915 Installation Manual

MX 900 Series Installation Guide

Removing and Installing Optional Components

This section discusses the installation procedures for the optional components
available for the MX 900 Series terminal. Your terminal may already have some
of these options, as modules can be installed at the factory or in the field.

Installing Countertop Wedge

The countertop wedge raises the rear section of the MX 900 Series terminal by
an angle of 10 degrees to facilitate use of the screen. See the Stand Mount
section for aligning the pins.
To install the countertop wedge
1. Align the pins in the countertop wedge with the two key holes on the
2. Slide the countertop wedge firmly into position.

Removing or Installing the I/O Module

Use the following steps to remove and install I/O modules.
1. Push down the two tabs and slide the I/O module out of the terminal.
May 13, 2015
bottom of the MX 900 Series terminal.
9