Compressors; Filters; Service Access; Recommended Drain Piping - York SUNLINE 2000 Installation Manual

FIGURE 4 - RECOMMENDED DRAIN PIPING

COMPRESSORS

Units are shipped with compressor mountings factory-
adjusted and ready for operation.
Do not loosen compressor mounting bolts.

FILTERS

51 mm (2") or 102 mm (4") filters can be supplied with
each unit. Filters must always be installed ahead of the
10
evaporator coil and must be kept clean or replaced with
same size and type. Dirty filters will reduce the capacity
of the unit and will result in frosted coils or safety shut-
down. Minimum filter area and required sizes are
shown in Physical Data Table 5.

SERVICE ACCESS

The following removable panels provide access to all
serviceable components:
• Compressor compartment
• Electric Heat compartment
• Side Supply & Return Air compartments
(Two panels)
• Blower compartment (Three panels)
• Main control box
• Filter compartment
• Outdoor Air compartment (Two panels)
Refer to the Unit Dimensions Figure 10 for location of
these access panels.
Make sure that all screws and panel latches
are replaced and properly positioned on the
unit to maintain an airtight seal.
66396-YIM-C-1004
Unitary Products Group