Chapter 5: Standard Chart Operations
➤ To receive the waypoint and route lists via
both display units - one unit will send waypoints, the other will receive them.
CAUTION:
Receiving waypoints from another
existing waypoint and route lists.
1. Display the waypoint list as previously described, then press the WAY-
POINT TRANSFER soft key.
2. Press the soft key SEND WPT LIST ON HSB or RECIEIVE WPTS FROM HSB. You
are prompted to confirm:
Press NO to cancel the operation, then ENTER if you wish to close the way-
point list.
Press YES to continue. The waypoint list is transmitted to/from the chart-
plotter from/to another instrument on
ferred the soft key changes to STOP SENDING WAYPOINTS; when the
transfer is complete the soft key is re-displayed.
, you must set-up the transfer on
hsb
2
hsb
2
instrument overwrites any
2
. While the data is being trans-
hsb
5-37