Sharp KS-R19S Service Manual page 9

1. Remove the body in accordance with "REMOVE OF BODY".
2. Disconnect the lead wires from heater plate ass'y and remove the screw holding temp. fuse angle.
3. Remove the temp. fuse ass'y from the temp. fuse angle. (Fig. 9)
4. Now the temp. fuse ass'y is free.
Note : When reassembly take care so that the charged part of temperature fuse assembly does not protrude
from the TUBE-TA and securely fix it to the temperature fuse angle and then fix it with a screw to the
outer pot.
1. Remove the body in accordance with "REMOVE OF BODY".
2. Disconnect 2 lead wires to the thermostat (cut off).
3. Remove 2 screws and detach the thermostat (cut off) from the outer pot.
4. Now the thermostat (cut off) is free.
Outer pot
1. Detach the dew receiver from the upper ring.
2. Insert a flat thin screwdriver or similar into the gap between upper ring hinge cover remove the hing cover.
3. Remove the clossed therminal (3 pcs.) and disconnect lead wires from the outer pot.
4. Fixing the shaft sus by using plier, remove the shaft sus from the lid ass'y.
5. Now the lid ass'y is free.
Upper ring
REMOVE OF TEMP. FUSE ASSEMBLY
REMOVE OF THERMOSTAT (CUT OFF)
Fig. 9
REMOVE OF LID ASSEMBLY
Shaft sus
Screw
Plier
Lid ass'y
9
Inner pot thermo angle
Thermostat (Cut off)
Temp. fuse ass'y
Temp. fuse angle
Fig. 10