1. Remove the bottom cover in accordance with "REMOVE OF BOTTOM COVER".
2. Remove 2 screws holding the lead wires
to the heater plate ass'y.
3. Remove 3 screws holding the heater
plate ass'y to the outer pot.
4. Now the heater plate ass'y is free.
1. Remove the bottom cover in accordance with "REMOVE OF BOTTOM COVER".
2. Disconnect the lead wires of the panel.
3. Remove the nut and 2 screws holding to the body.
4. Insert the flat type screwdriver into the gap between the upper ring and latch hook cover, to pry the latch hook
cover from the upper ring.
5. Detach the dew receiver from the upper ring.
6. Insert the flat type screwdriver or similar to pry the claw of the hinge cover and remove it.
7. Separate the body from the upper ring by rubber hammer knock the upper ring. Fig. 6
8. Remove the panel in accordance with "REMOVE OF PANEL".
9. Now the body is free.
Upper ring
Flat type screwdriver
Body
REMOVE OF HEATER PLATE ASSEMBLY
Fig. 5
REMOVE OF BODY
Lacth hook cover
Panel
Latch hook cover
Fig. 6
Screw
7
Heater plate
Screw
Outer pot
Screw
Nut
Screw
Dew receiver
Body
To knock
Hinge cover