Rangemaster ELAN U105510-01 Installation And User Manual page 30

Moving the Cooker
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker.
Ensure that the fl oor covering is fi rmly fi xed, or
removed to prevent it being disturbed when moving
the cooker around. You will need the levelling tool.
Pull the warmer drawer out to its furthest point.
Lift it up and out.
Fit the levelling tool on the rectangular adjuster as
shown below.
LOWER THE FRONT ROLLER by doing 14 complete
(360°) turns clockwise. (This means turning and
removing the levelling tool 56 times).
Now LOWER THE TWO REAR ROLLERS.
First fi t the levelling tool on the hexagonal adjusting
nut as shown below.
Make 10 complete (360°) turns clockwise. (This
means turning and removing the levelling tool 20
times).
Make sure you lower BOTH REAR ROLLERS. There
are two adjusting nuts, one for each roller, at both the
front bottom corners of the cooker.
Carefully push the cooker backwards close to its fi nal
position leaving just enough space to get behind it.
Take care not to damage the power cable.
Do not use the door handles or control knobs to
manoeuvre the cooker. Remove the pack base tray.
Levelling
You are recommended to use a spirit level on a shelf
in one of the ovens to check for level.
Place the cooker in its intended position taking care
not to twist it within the gap between the kitchen units
as damage may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To
adjust the height of the rear of the cooker use the
levelling tool supplied to turn the adjusting nuts at the
front bottom corners of the cooker.
Adjust the height of the front roller to level the cooker.
Turn clockwise to raise the cooker and anticlockwise
to lower.
When you are satisfi ed with the height and level
raise the front of the cooker by one turn of the front
roller adjuster. Screw down the front feet to meet the
fl oor. Screw the front roller adjuster anticlockwise to
raise the front roller so that the front of the cooker is
supported on the feet, not the front roller, to prevent
accidental movement of the cooker.
Leave the levelling tool on the adjuster with the
handle of the tool facing the rear of the cooker, so
that the customer can use it if they wish to move
the cooker.
Replace the drawer by locating on side runners and
push in.
30