Panasonic AG-HMX100P Operating Instructions Manual page 25

 NOTE
The same input sources are assigned to the A/PROG bus and
the B/PRESET bus.
It is impossible to assign different sources to each bus.
PVW connector.
To set the video and audio input sources
Video and sound are allocated to input source numbers 1
Allocate the video input sources named [V S-1], [V S-2],
[V S-3], and [V S-4] to any of numbers 1 to 8, specifying
the video input sources to use.
Allocate the audio input sources named [A S-1], [A S-2],
[A S-3], and [A S-4] to any of numbers 1 to 8, specifying
the audio input sources to use.
correspondence between video input sources and audio

To allocate video and audio to the selected
number
Select one of the video input sources [V S-1], [V S-2],
[V S-3], and [V S-4] using the rotary 2 control.
the video input sources [V S-1] to [V S-4] using the rotary 3
control.
Each input type supports the signal formats as shown
below.
Input Format
All formats
Select one of the audio input sources [A S-1], [A S-2],
control.
sources [A S-1] to [A S-4] using the rotary 5 control.
 NOTE
If the system format is set to SD (  page 19), [HDMI] cannot
be selected. If the system format is set to HD, [VIDEO]
cannot be selected.
You cannot set the combinations of video and audio
input sources shown in the table below. (The settings are
automatically changed to available values.)
When the video input is HDMI, only two channels of audio
sources can be input.
Video Input Audio Input
To fix the settings and return to the [AUDIO
VIDEO] screen
Press the
settings, press the
 NOTE
If other menu screen is displayed without fixing of the settings
on the Audio/Video Input Source Setting screen, those settings
are revoked and not applied.
To associate video input with audio input
1
Set [INPUT] to [V-LINK] using the rotary 2
control, and press the
2
When the message [OK?] appears, press the
key again.
Audio input sources corresponding to the video
input sources assigned to 1 to 8 are set.
To cancel the setting, press the
holding the SHIFT key.
The display returns to the [SETUP] menu screen.
 NOTE
For input settings in 3D mode, it is possible to select only
combinations of image input sources and audio input sources
which are associated with each other. When 3D mode is set to
other than [OFF], [V-LINK] does not appear as the setting item.
To use the factory default settings
1
Set [INPUT] to [DEFAULT] using the rotary 2
control, and press the
2
When the message [OK?] appears, press the
key again.
key.
key while
key.
25