Positioning The Hob - Rangemaster RGG60 User Manual & Installation & Service Instructions

Rangemaster gas hob user guide & installation & service instructions
Table of Contents

Advertisement

Check the appliance is electrically safe and gas sound when you have finished.
Fig.5-1
���
ArtNo.316-0016 RGG60 cutout dims
���
���������
��������
Fig.5-2
ArtNo.316-0011 60cm hob clearances Gas
�����
���
Fig.5-3
INSTALLATION
You will need the following equipment to complete the hob
installation satisfactorily:
���
You will also need the following tools:
1.
2.
3.
4.
5.
6.
7.
���
Checking the Parts
Check that the appliance is in a good condition after having
removed the packaging. In case of doubt, do not use the
appliance and contact the retailer.
The hob also has 4 individual pan supports.
����
Never leave the packaging materials (cardboard,
���
plastic bags, polystyrene foam, etc.) within children's
reach since they could become potential sources of
danger.

Positioning the Hob

The hob should be fitted into a work surface, which is
at least 600mm deep. In position, it has a maximum
thickness of 50mm from the top of the work surface.
The cut-out dimensions are shown in (Fig.5-1) and
the minimum clearances in (Fig.5-2). The minimum
recommended distances from the hob to nearby surfaces
are shown in (Fig.5-3).
Any hob hood should be installed in accordance with the
���������
hood manufacturer's instructions.
Surfaces of furniture and walls at the sides and rear of the hob
should be heat, splash and steam resistant. Certain types of
vinyl or laminate kitchen furniture are particularly prone to
heat damage and discolouration.
We cannot accept responsibility for damage caused by
�����
���
normal use of the hob to any material that de-laminates
or discolours at temperatures less than 65°C above room
temperature.
For safety reasons curtains must not be fitted immediately
behind the hotplate.
Conversion to LP
If the appliance is to be converted to LP gas do the
conversion at this point. See the conversion section of these
instructions.
8
Gas Pressure tester
Flexible gas hose
Multimeter
Electric drill
Jigsaw
Steel tape measure
Cross head screwdriver
Pencil
Adjustable spanner
Sharp knife

Advertisement

Table of Contents
loading

Table of Contents