Auxiliary Bus Control Block - Sony MVS-6000 User Manual

Auxiliary Bus Control Block

SNAP
EFF
SHOT
SHOT
MCRO
BOX
TRANS
RATE
M/E
P/P
1
AUX AUX
1 2
2 Bank selection buttons
a AUX delegation buttons
Press one of these buttons, turning it on, to
select the bus to assign to the key row of the
bank selected with the bank selection
buttons. These 10 buttons from left to right
have ID numbers 1 to 10. When the
[SHIFT] button is enabled, their ID
numbers switch to 11 to 20. Pressing one of
the buttons selects the bus assigned to the
ID number. That is, you can select up to 20
buses using these AUX delegation buttons
in combination with the [SHIFT] button.
The assignment of buses to the ID numbers
can be done in a Setup menu.
For buses that can be selected, see "Bus
Selection" (page 97).
For each bank, the key row is shared
between the auxiliary bus control block and
cross-point control block. Priority is given
to the control block in which the delegation
MASTR ALL UNDO
M/E USER USER STORE
P/P
1 1 2 STATS
DME DME DME DME
STORE
1 2 3 4
P-BUS GP1 RCALL
AUX AUX AUX AUX AUX
3 4 5 6 7
1 AUX delegation buttons
+/-
9
8 EFF
7
DISS
CLR
4
5 6 AUTO
TRANS
TRIM
2
1 3
GPI
ENBL
0
ENTER
FMS FMS EDIT
KEY
1 2 PVW
3 KEY button
button is last pressed. When priority is
given to the cross-point control block, all
these buttons go off.
b Bank selection buttons
These select the bank for which the AUX
delegation buttons are enabled.
c KEY button
While this button is held down, you can use
the cross-point row of buttons to select key
signals.
d SHIFT button
While this button is enabled, the AUX
delegation buttons have the shifted ID
numbers. In a Setup menu, you can select
one of the following three modes for this
button.
• The button takes effect while being held
down.
Names and Functions of Parts of the Control Panel
SHIFT
4 SHIFT button
49