IBM xSeries 440 Troubleshooting Manual page 51

Code Function
202 Processor cache
203 External cache
206 Diskette drive
Result
Aborted Test setup error: BIOS cannot access VPD
information
Test setup error: Corrupt DMI BIOS. Information in
BIOS is not as expected
Test setup error: No L2 cache detected on
microprocessor socket id xyz or BIOS setup problem
(where xyz identifies the microprocessor that is
causing the error message)
Test setup error: Unknown hardware problem
associated with microprocessor in socket id xyz.
(where xyz identifies the microprocessor that is
causing the error message)
Failed Microprocessor in socket ID xyz
(where xyz identifies the microprocessor that is
causing the error message)
Warning Test setup error: Processor cache is disabled. Use
system setup to enable before retrying the test
Aborted Test setup error: Hardware problem associated with
microprocessor/system board
Failed Data pattern test failure
Directory test failure
Set associativity test failure
Memory controller: Internal register test failure
Warning External cache is disabled
Failed Internal diskette drive bay
Description Action
If your server does not
have the latest level
BIOS code installed,
update the BIOS code
to the latest level and
run the diagnostic
program again.
If the problem persists,
call for service.
1. If your server does
not have the latest
level BIOS code
installed, update the
BIOS code to the
latest level
2. Run the diagnostic
program again.
3. If the problem
remains, replace the
failing processor.
If the problem persists,
call for service.
1. Reseat the
identified
microprocessor.
2. If the problem
remains, replace the
microprocessor.
If the problem persists,
call for service.
Use the Cache Control
choice from the
Advanced Setup menu
to enable the processor
cache.
If the problem persists,
call for service.
Call for service.
Run the
Configuration/Setup
Utility and enable the
external cache, then
rerun the test.
If the problem persists,
call for service.
Call for service.
Chapter 2. Solving Problems
39