Small Computer System Interface (Scsi) Messages - IBM xSeries 440 Troubleshooting Manual

Small computer system interface (SCSI) messages

If you receive a SCSI error message when running the SCSISelect Utility program,
one or more of the following might be causing the problem:
•
•
•
•
•
•
•
To solve the problem, verify that:
•
•
•
•
If you have verified these items and the problem persists, run the diagnostic programs
to obtain additional information about the failing device. If the error remains or recurs,
call for service.
Note: If your server does not have a hard disk drive, ignore any message that
A failing SCSI device (adapter, drive, controller)
An improper SCSI configuration
Duplicate SCSI IDs in the same SCSI chain
An improperly installed SCSI terminator
A defective SCSI terminator
An improperly installed cable
A defective cable
The external SCSI devices are turned on. External SCSI devices must be turned
on before the server.
The cables for all external SCSI devices are connected correctly.
The last device in each SCSI chain is terminated properly.
The SCSI devices are configured correctly.
indicates that the BIOS code is not installed.
Chapter 2. Solving Problems
31