Radio Shack 02A01 Owner's Manual page 3

2. Plug one end of the supplied short modu-
lar cord into the
LINE
the base. Route the modular cord through
the strain relief channel.
3. Plug the cord's other end into the wall
plate jack, then align the base's keyhole
slots with the wall plate studs and slide
the phone downward to secure it.
4. Press and lift up the handset holder,
rotate it 180°, then snap it back so it holds
the handset.
To mount the phone directly on a wall, in addi-
tion to the preceding steps, you need two
screws (not supplied) with heads that fit into
the keyhole slots on the bottom of the base.
Drill two holes 3 / inches (100 mm) apart.
15
16
Then thread a screw into each hole, letting the
5
heads extend about /
16
the wall.
Substitute the long modular cord for the short
cord mentioned in step 2.
Connecting the Handset
Plug one end of the coiled cord into the modu-
lar jack on the handset. Then connect it to the
jack on the left side of the telephone base.
Note: Your local RadioShack store sells a va-
riety of longer coiled handset cords, which are
especially useful when you mount the phone
on a wall.
Using Handset Volume Control
Use the handset's rotary control to adjust the
handset volume to the desired level.
Using Multi-Pitch Control
Slide the pitch switch to select a different
1/2/3
ringer tone.
Setting the Ringer
jack at the back of
If you do not want to hear the phone ring, set
RINGER
the ringer off, and you can answer calls if you
hear another phone on the same phone line
ring. The bar-shaped ring indicator flashes
when the phone rings, even when the ringer is
off. If you want to hear the phone ring, set
RINGER
Setting the Dialing Mode
Set the
phone for the type of service you have. If you
are not sure which type you have, do this sim-
ple test.
inches (8mm) from
Using Special Tone Services
Some computer services, such as alternate
long distance and bank-by-phone, require
tone signals for communications.
If you have pulse service, you can still use
special tone service by following these steps.
3
to . You can still make calls with
OFF
to or .
HI LO
switch on the back of the
TONE/PULSE
1. Set to
TONE/PULSE TONE
set and listen for a dial tone.
2. Press any number except
requires that you dial an access code (9,
for example) before you dial an outside
number, do not press the access code
number either.
If the dial tone stops , you have touch-
tone service. Leave the setting to
If the dial tone continues , you have pulse
service. Set
TONE/PULSE
1. Connect to the special service using
pulse dialing.
2. When the special service answers,
change the
TONE/PULSE
or press to temporarily switch to tone
*
dialing.
. Lift the hand-
. If your phone
0
.
TONE
to .
PULSE
switch to ,
TONE