Reinstall Kick Plate; Complete Installation - Jenn-Air 8284756 Installation Instructions Manual

15. Lift up on the control console and set it back into place.
For a proper fit, the flange of the control console must hook
over the lip on the front of the range cooktop.
A
B
A. Control console flange
B. Front lip of range cooktop
16. Check that the control console is flush with the top edge
of the range.
A
A. Flush with range top
17. Replace the 2 screws on each side of the control console.
18. Replace the control knobs.
19. Replace burner grates.
20. Test the flame by turning the control from LO to HI,
checking the flame at each setting.

Reinstall Kick Plate

1. Align shoulder screw mounting holes with shoulder screws
on range.
2. Push kick plate down against front of range until the top
screw holes are aligned with the mounting holes on the
front of the range.
3. Reattach screws to the top of the kick plate.
B
A
A. Kick plate
B. Reattach these screws.
C. Top screw hole
D. Shoulder screw mounting hole
C
D

Complete Installation

1. Check that all parts are now installed. If there is an
extra part, go back through the steps to see which
step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For oven use and cleaning, read the Use and Care Guide.
Check Operation of Oven Bake Burner(s)
1. Remove the oven racks and bake burner cover and set
them aside on a covered surface.
2. Start a Bake cycle. See the Use and Care Guide for
operating instructions.
The oven bake burner should light within 8 seconds. Under
certain conditions it may take the burner up to 60 seconds
to light.
Electronic igniters are used to light the bake burners.
NOTE: No adjustments can be made to the bake flames.
Check Operation of Oven Broil Burner
1. Remove the oven racks and set them aside on a
covered surface.
2. Start a Broil cycle. See the Use and Care Guide for
operating instructions.
The oven broil burner should light within 8 seconds. Under
certain conditions, it may take the burner up to 60 seconds
to light.
Electronic igniters are used to light the broil burner.
NOTE: No adjustments can be made to the broil flames.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the
Use and Care Guide or contact the dealer from whom you
purchased your range.
15