Replacing The Fuse; The Fcc Wants You To Know - Radio Shack MPA-125 Owner's Manual

32-2003.fm Page 17 Tuesday, March 28, 2000 10:45 AM

REPLACING THE FUSE

If the amplifier does not operate, you might
need to replace the fuse on the back of the
amplifier with the supplied (or another) 3-
amp, 250-volt fuse.
Important: Let the amplifier cool down and
see if it starts again before you assume a
fuse needs to be replaced.
Caution: Do not use a fuse with ratings other
than those specified. Doing so might damage
your amplifier.
1. Unplug the amplifier.
2. Use a Phillips screwdriver to remove the
fuse holder cap on the back of the ampli-
fier, then pull out the cap to remove the
fuse.
3. If the fuse is blown, replace it.
4. Insert the fuse into the fuse holder's
socket, press the fuse holder back into
the amplifier, then use a Phillips screw-
driver to replace the fuse holder cap.
THE FCC WANTS YOU TO
KNOW
Your amplifier might cause TV or radio inter-
ference even when it is operating properly.
To determine whether your amplifier is caus-
ing the interference, turn off your amplifier. If
the interference goes away, your amplifier is
causing it. Try to eliminate the interference
by:
• moving your amplifier away from the
receiver
• contacting your local RadioShack store
for help
Care and Maintenance
17