Chamberlain MotorLift RA10 Instructions Manual page 12

A Carton Contents
1. Motor (1)
2. Hardwarebag
• Adjuster pin (2)
• Drive adapter safety catch(RA10 - RA30) (3)
• Square pin (RA50) (5)
• Square pin 25mm (RA10 - RA30) (6)
(3)Manual
(4)Drive adapter (7)
(5)Mounting bracket (8)
Tubular Motors with mechanical limit switches
Model Diameter Torque
(mm) (Nm)
RA10 35 10
RA20 45 14
RA30 45 19
RA50 45 36
Warranty for Tubular Motor
Chamberlain GmbH warrants to the first retail purchaser of this product that the product shall be free from any defect in materials
and/or workmanship for a period of 60 full months (5 years) from the date of purchase for RA10, RA20, RA30 or RA50 Series
Models. Upon receipt of the product, the first retail purchaser is under obligation to check the product for any visible defects.
Conditions: The warranty is strictly limited to the reparation or replacement of the parts of this product which are found to be
defective and does not cover the costs or risks of transportation of the defective parts or products.
This warranty does not cover non-defect damage caused by unreasonable use (including use not in complete accordance with
Chamberlain's instructions for installation, operation and care; failure to provide necessary maintenance and adjustment; or any
adaptations of or alterations to the products), labor charges for dismantling or reinstalling of a repaired or replaced unit or
replacement batteries.
A product under warranty which is determined to be defective in materials and/or workmanship will be repaired or replaced
(at Chamberlain's option) at no cost to the owner for the repair and/or replacement parts and/or product. Defective parts will be
repaired or replaced with new or factory rebuilt parts at Chamberlain's option.
If, during the warranty period, the product appears as though it may be defective, contact your original place of purchase.
This warranty does not affect the purchaser's statutory rights under applicable national legislation in force nor the purchaser's
rights against the retailer arising from their sales purchase contract. In the absence of applicable national or EC legislation, this
warranty will be the purchaser's sole and exclusive remedy, and neither Chamberlain GmbH nor its affilliates or distributors shall
be liable for any incidental or consequential damages for any express or implied warranty relating to this product.
No representative or person is authorized to assume for Chamberlain GmbH any other liability in connection wit the sale of
this product.
(RA50) (4)
Speed Operating
Voltage
(RPM) (V)
14 230
15 230
15 230
15 230
Before You Begin:
1. Carefully read all the information contained in this Owner's
Manual before beginning installation procedures.
2. Check the shutter to be sure it is not broken or damaged,
and that it opens and closes smoothly.
3. Determine whether the motor needs to be installed on the
left side (a) or the right side, (b) of the shutter – Figure
Install it on the side where the manual pull is located. Close
the shutter.
4. Ensure that the motor can be pushed in as far as the stop.
The limit switch is controlled by the plastic ring which
must be pushed fully on.
Frequency Current Motor
input Rating
(Hz) (A) (W)
50 0.40 100
50 0.67 155
50 0.77 175
50 1.18 230
E
Operating Limit
Switch
time
Range
(U)
(min)
38
4
38
4
38
4
38
4
.