Radius-Server Dead-Criteria Time - Cisco CRS User Manual

radius-server dead-criteria time

radius-server dead-criteria time
To specify the minimum amount of time, in seconds, that must elapse from the time that the router last received
a valid packet from the RADIUS server to the time the server is marked as dead, use the radius-server
dead-criteria time command in global configuration mode. To disable the criteria that were set, use the no
form of this command.
radius-server dead-criteria time seconds
no radius-server dead-criteria time seconds
Syntax Description
seconds
Command Default
If this command is not used, the number of seconds ranges from 10 to 60 seconds, depending on the transaction
rate of the server.
Command Modes
Global configuration
Command History
Release
Release 3.3.0
Usage Guidelines
If you configure the radius-server dead-criteria time command before the radius-server deadtime
Note
command, the radius-server dead-criteria time command may not be enforced.
If a packet has not been received since the router booted and there is a timeout, the time criterion is treated
as though it were met.
Task ID
Task ID
aaa
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
46
Length of time, in seconds. The range is from 1 to120 seconds. If the seconds argument is
not configured, the number of seconds ranges from 10 to 60, depending on the transaction
rate of the server.
The time criterion must be met for the server to be marked as
Note
dead.
Authentication, Authorization, and Accounting Commands
Modification
This command was introduced.
Operations
read, write
OL-24740-01