Out-Of-Band - Cisco CRS User Manual

Management Plane Protection Commands

out-of-band

To configure out-of-band interfaces or protocols and to enter management plane protection out-of-band
configuration mode, use the out-of-band command in management plane protection configuration mode. To
disable all configurations under management plane protection out-of-band configuration mode, use the no
form of this command.
out-of-band
no out-of-band
Syntax Description
This command has no keywords or arguments.
Command Default
None
Command Modes
Management plane protection out-of-band configuration
Command History
Release
Release 3.6.0
Usage Guidelines
Use the out-of-band command to enter management plane protection out-of-band configuration mode.
Out-of-band refers to an interface that allows only management protocol traffic to be forwarded or processed.
An out-of-band management interface is defined by the network operator to specifically receive network
management traffic. The advantage is that forwarding (or customer) traffic cannot interfere with the management
of the router.
Task ID
Task ID
system
Examples The following example shows how to enter management plane protection out-of-band configuration mode
using the out-of-band command:
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# control-plane
RP/0/RP0/CPU0:router(config-ctrl)# management-plane
RP/0/RP0/CPU0:router(config-mpp)# out-of-band
RP/0/RP0/CPU0:router(config-mpp-outband)#
OL-24740-01
Modification
This command was introduced.
Operations
read, write
Cisco IOS XR System Security Command Reference for the Cisco CRS Router, Release 4.1
out-of-band
175