Storing Text Tags; Assigning A Text Tag To A Channel - Radio Shack PRO-92 Owner's Manual

20-522.fm Page 37 Friday, September 17, 1999 12:46 PM
• Your scanner automatically rounds the entered
frequency to the nearest valid frequency. For
example, if you enter a frequency of 151.473, your
scanner accepts it as 151.470.
• Press then press
FUNC
function on or off. If you want the scanner to
pause 2 seconds on this channel after a transmis-
sion ends before it proceeds to the next active
transmission, see "Using the Delay Function" on
Page 48. The scanner also stores this setting in
the channel.
• If you are storing frequencies for an EDACS sys-
tem, you must store them in logical channel num-
ber order, with the first frequency in channel 1 for
the current bank.
5. If necessary, press
mode. If you select
code by pressing
upward) or
FUNC
ward through the codes).
6. If desired, program a text tag for the channel (see

"Assigning a Text Tag to a Channel").

7. The next channel in sequence is ready for program-
ming. Press
PGM

STORING TEXT TAGS

You can customize your scanner by storing text tags (up
to 12 characters) for easy identification of channel trans-
missions, trunk ID's, or banks.
Assigning a Text Tag to a Channel
To input the text, follow these steps:
1. Press , enter the channel number where
MANUAL
you want to enter the text, then press
again. M and the channel number appear at the
upper left corner on the display (for example: M100).
2. Pressing changes
PGM
to turn the delay
DELAY/1
to change the receiving
MODE
P/L or DPL , enter the PL or DPL
(to move through the codes
STEP
then press (to move down-
STEP
and then repeat Steps 3 through 5.
M to P on the display.
MANUAL
37