Storing Text Tags - Radio Shack PRO-2067 Owner's Manual

4. Press
ENTER
quency into the channel.
Notes:
• If you made a mistake in Step
3, Invalid Freq
and the scanner beeps when
you press
again from Step 3.
• Your scanner
rounds the entered frequency
down to the nearest valid fre-
quency. For example, if you
enter a frequency of 151.473,
your scanner accepts it as
151.470.
• The scanner
pauses 2 seconds on a channel
after a
before it proceeds to the next
channel. To turn off delay, press
then
FUNC
Delay" on Page 30).
5. If necessary, change the receive
mode (see "Changing the Receive
Mode" on Page 33). If you select
PL or DPL mode, enter the PL or
DPL code by pressing
move through the codes upward)
or then
FUNC
through the codes downward).
6. To program the next channel in
sequence,
repeat Steps 3 through 5.

STORING TEXT TAGS

You can customize your scanner by
storing text tags (up to 12 characters)
to store the fre-
appears
. Simply start
ENTER
automatically
automatically
transmission ends
. (See "Using
DELAY
STEP
(to move
STEP
press
PROG
for easy identification of channel
transmissions, trunk IDs, or banks.
Assigning a Text Tag to a
Channel
1. Press
ber or channel number where you
want to enter the text, then press
MAN
number appear at the upper left
corner of the display (for example:
M100).
2. Press
the display.
3. Press
at the third line on the display.
4. Enter the desired text using the
number keys (see "Text Input
Chart" on Page 24).
Note: If you make a mistake,
press
acter you want to change.
5. Press
(to
Assigning a Text Tag to a
Bank
1. Select
desired bank by pressing
and entering the 3-digit bank num-
and
ber (000 for bank 0 or 200 for
bank 2, for example). Press
again, then press
2. Press
appears at the 3rd line on the dis-
play.
, enter the bank num-
MAN
again. M and the channel
. M changes to
PROG
. The cursor appears
TEXT
or to move to the char-
to input the text.
ENTER
a channel
PROG
then . The cursor
FUNC 6
P on
within the
MAN
MAN
.
23