Sequencer; Table 6-18 Sequencers 1-4 Parameters Fixed Addresses; Table 6-19 Sequencer 1-4 Step 1 Fixed Addresses - Honeywell HC900 User Manual

Parameters accessible with Function Code 03, 06,10h

Sequencer

6.11 Sequencer
Summary
In the fixed map each Sequencer uses three non-contiguous sections of the map:
 Sequencer parameters (Table 6-21)
 Sequencer steps (Table 6-21)
 Sequencer states (Table 6-21).
In a custom map the above parameters are contiguous.
Function Code Support
Read – Function Code 3
Write – Function Code 16 (10 hex)
Sequencers 1-4 Parameter Addresses
The addresses given in Table 6-18 do not necessarily apply to sequencers in the custom map. For custom
addresses view or print a report in HC Designer.
Sequencer #1 Parameters
Sequencer #2 Parameters
Sequencer #3 Parameters
Sequencer #4 Parameters
Sequencers 1-4 Step 1 Addresses
The addresses given in Table 6-19 do not necessarily apply to sequencer steps in the custom map. For
custom addresses view or print a report in HC Designer.
Sequencer #1 Step 1 Table
Sequencer #2 Step 1 Table
Sequencer #3 Step 1 Table
Sequencer #4 Step 1 Table
Sequencers 1-4 State Addresses
The addresses given in Table 6-20 do not necessarily apply to sequencer states in the custom map. For
custom addresses view or print a report in HC Designer.
74

Table 6-18 Sequencers 1-4 Parameters Fixed Addresses

Table 6-19 Sequencer 1-4 Step 1 Fixed Addresses

HC900 Process Controller Communications User Guide
Starting Starting
Address Register
(Hex) (Decimal)
5AA0 23201
5D00 23809
5F60 24417
A000 40961
Starting Starting
Address Register
(Hex) (Decimal)
5AC0 23233
5D20 23841
5F80 24449
A020 40993
Ending Ending
Address Address
(Hex) (Decimal)
5AB5 23222
5D1F 23840
5F7F 24448
A01F 40992
Ending Ending
Address Address
(Hex) (Decimal)
5CBF 23744
5F1F 24532
617f 24960
A21F 41504
Revision 13
April 2017