Changing The Operation Mode; Switching To Protected Operation Mode; Switching To Configuration Mode - Mitsubishi Electric FX2N-32ASI-M User Manual

FX2N-32ASI-M AS-interface Block
6.1

Changing the Operation Mode

6.1.1

Switching to Protected Operation Mode

The configuration mode is ended by pressing the "MODE" button. The mode changes to
protected operating mode. At this time, 32ASI-M follows these rules for pressing the "MODE"
button:
• Less than 5 seconds
32ASI-M exits the configuration mode without copying the configuration to setpoint
configuration.
• More than 5 seconds
32ASI-M exits the configuration mode simultaneously copying the configuration to setpoint
configuration. At this time, 32ASI-M stores this configuration to LPS, and stores the actual
configuration to permanent configuration, too.
Note:
If the system recognizes a slave with address 0 on the AS-interface, it can not leave the
configuration mode.
6.1.2

Switching to Configuration Mode

The Protected operation mode is ended by pressing the "MODE" button for more than 5
seconds. The mode changes to Configuration mode.
Configuration Mode and Protected Operating Mode 6.
6-2