Furuno Felcom15 Operator's Manual page 27

9. To escape from the test, press the [Esc] key twice on the terminal unit. The test mode is
stopped and the message shown below appears to notify you that normal operation has
been restored.
INF: SSAS Buttons returned to NORMAL OPERATION.
Further, because the button remains pushed in ( ), the message "Please return the
SSAS button into OFF-STATE." appears.
10. Push the button again to pop it out ( ).
11. Close the button cover.
12. Press the [Esc] key three times to return to the standby display.
Note: If the button is left pushed in ( ) when the communication unit is turned on, the
equipment will go into the test mode if the SSAS is not transmitting repeatedly. To
return to the standby display, push the button again to pop it out (
the communication unit off and on again.
FELCOM 12
1. Press the [F7] key to open the Options menu.
2. Press the [6] key if the FELCOM 12 operates as an Inmarsat C MES or the [5] key if it
operates as an EGC receiver.
3. Press the [4] key.
4. Press the [Enter] key to start the test mode.
CAUTION
<Press ESC key to continue>
Test
1. PV Test
2. PV Test Result
3. Diagnostic Test
4. SSAS Button Test
Test menu
Options
Test
1. Login
Distress/SSAS Button Test
2. Logout
1. PV Test
3. Abort
2. PV Test Result
4. Select NCS
3. Self Test
5. Ocean Region
4. Distress Alarm Button Test
6. Test
Start window
25
Start
Yes No
) and then turn