Setting Ssas Report Destination And Message Contents - Furuno Felcom15 Operator's Manual

3.2 Setting SSAS Report Destination and
Message Contents
When the SSAS is activated, the SSAS report is sent according to the addresses (max. 5)
and message content set with SSAS Report 1 – SSAS Report 5 on the SSAS Report menu.
Note 1: The destination and message content of an SSAS report varies according to
Administration. Therefore, set them as requested by ship's authorities. For
information other than ship's name, MMSI no. and IMN no., set it manually with
"Other Inf."
Note 2: The equipment must be in the SSAS manager mode to execute this procedure.
See paragraph 3.1.2.
1. Press the [F5] to open the Reports menu.
2. Press the [4] key to shown the SSAS Report menu.
3. Press [1], [2], [3], [4] or [5] key as appropriate.
Note: When the button is tested on the FELCOM 12, the test report is sent to the
station having the youngest SSAS report number. Therefore set at SSAS Report
1 the station which is to receive the test report.
1. Data Report
2. Message Report
3. Data Network ID
4. SSAS Report
SSAS Report
1. SSAS Report 1
2. SSAS Report 2
3. SSAS Report 3
4. SSAS Report 4
5. SSAS Report 5
6. Message Contents
SSAS Report
ON
Status
Real+Test
Mode
Station Name
TELEX
Destination Type
Prefix Code
Country/Ocean Code
Station ID
Modem Type
Address
Subject
LES ID
02:00 (hh: mm)
Report Interval
SSAS report window (FELCOM 15/FELCOM 16)
Reports
16