Trackball Control Unit (Option) - Furuno FAR-1513 Installation Manual

4. Orient the fixing plate as shown in the figure below, then fix the plate in place with
the two screws removed at step 2.
Check that the cable is aligned with the fixing plate and facing the rear of the con-
trol unit.
5. Secure the cable to the fixing plate with a cable tie (local supply).
1.8

Trackball Control Unit (option)

How to mount the unit tilted
Use the desk fixing plate to mount the unit tilted on a desktop. Fasten the desk fixing
plate to the bottom of the control unit. Fasten the control unit to the desktop with self-
tapping screws (local supply).
How to mount the unit flush with mounting surface
Drill four mounting holes of 5 mm in diameter in the mounting location, referring to the
outline drawing at the back of this manual. Fasten the control unit with four M4 screws
(local supply) from the underside of the desk.
Fixing plate
Control unit cable
Desk fixing plate
1. INSTALLATION
Cable tie Cable tie
1-13