Table of Contents
Advertisement
2.2 BACK OF THE METER (Continued)
2.3 DISASSEMBLY
You may need to open up the meter for one of the following reasons:
*
To check or change the 115 or 230 Vac power jumpers.
*
To install or remove calibration jumper on the main board.
Disconnect the power supply before proceedings.
To remove and access the main board, follow these steps:
1.
Disconnect the main power from the meter.
2.
Remove the front lens.
3.
Pull the meter forward, out of its case.
Figure 2-3. dc-Power Connections
6
Hide quick links:
Advertisement
Table of Contents
