Table of Contents
Advertisement
KEYPAD
[ 16/9 ] Key
Immediately recalls channel 16 from any channel location. Holding down
this key recalls channel 9. Pressing the [ 16/9 ] key again reverts to the
previous selected working channel.
Secondary use
Please see secondary use for the [ WX ] and [ MEM ] key.
[ WX ] Key
Immediately recalls the previously selected NOAA weather channel from
any channel location.
Secondary use
1. Holding down the [ 16/9 ] key while pressing the [ WX ] key changes
the mode from USA to International or Canadian.
NOTE: If position is displayed, this icon will be hidden.
2. Holding down the [ WX ] and [ SCAN ] key while turning the power on
resets the microprocessor and erases scan channels from memory.
This clears the memory and establishes the factory-set defaults. For
a list of these defaults, see the section on Resetting the Transceiver's
Microprocessor.
[ SCAN ] Key
1. Starts and stops scanning of programmed channels.
2. If held while the [ UP ( p )] or [ DOWN ( q )] key on the microphone are
pressed or CHANNEL selector knob on radio is turned, the radio will
show the channels programmed in scan memory. This function will
not work if the unit is scanning.
NOTE: The priority channel is channel 16 only.
[ H/L ] Key
Toggles between high and low power. When the [ H/L ] key is pressed
while the transceiver is on channel 13 or 67, the power will temporarily
switch from LO to HI power until the PTT is released. The [ H/L ] key does
not function on transmit inhibited and low power only channels.
Secondary use
Press and hold [ H/L ] key, when connected to the GPS receiver, the LCD
displays Position Data, Time, SOG (Speed Over Ground), and COG
(Course Over Ground) from the GPS.
Page 14
FCC ID: K66GX1280S
GX1280S
Vertex Standard Co., Ltd.
Advertisement
Table of Contents
