Installing An Spe Subcard - HP A8800 Installation Manual

Figure 13 Removing the protection cover
Move the ejector levers of the card outward. Supporting the bottom of the card with both hands,
2.
slowly push the card into the slot along the slide rails.
Push the ejector levers inward to ensure close contact between the card and the backplane.
3.
Position the screws in the holes and fasten them with a screwdriver to attach the card.
4.
Figure 14 Installing a card

Installing an SPE subcard

CAUTION:
Do not install a subcard to the SPE card when the router is powered on.
This section describes how to install a subcard to an SPE card. The installation of an SPE card is the
same as a common card. For more information, see
The subcards are not hot-swappable. You can install a subcard using one of the following methods:
Power off the router and install the subcard to the SPE card on the router.
•
When the router is powered on, install the subcard to the SPE card that has not been installed,
•
and then install them to the router.
To prepare for installation:
Put on an ESD-preventive wrist strap and make sure it is properly grounded.
1.
Make sure the router is powered off and installed with the SPE card.
2.
"Installing a card"
15