Replacing An Ac Power Supply - HP A8800 Installation Manual

Figure 30 Replacing a DC power supply
(A) DC power supply to be removed

Replacing an AC power supply

Pull the handle of the power supply downward to the unlock position. Gently move the power
1.
supply to separate it from the backplane of the power frame.
Supporting the bottom of the power supply with one hand and holding the power supply
2.
handle with the other hand, gently pull the power supply out.
Put the removed power supply on an antistatic mat or into the original shipping materials.
NOTE:
If the power frame is installed with two AC power supplies, repeat steps 1 and 2 to remove the other
power supply.
Use a Phillips screwdriver to loosen the captive screws on both sides of the power frame.
3.
Supporting the bottom of the power frame with one hand and holding the power frame handle
4.
with the other hand, gently pull the AC power frame out along the slide rails.
Place a removed power frame in an antistatic bag or its original shipping materials.
(B) DC power supply to be installed
49