Wireless Mode; Wired Mode; Channel Led; Mix In Jack - Shure PSM 200 User Manual

Wireless Mode

When you are using the P2R as a wireless receiver, or as a combination wired and wireless receiver, use the SELECT button on
the side of the P2R Receiver to set the frequency channel (1–8).
To Select a Frequency Channnel:
1. Press and hold the SELECT button until the CHANNEL LED indicator begins to flash.
2. When the LED indicator is flashing, press the SELECT button to scroll to the desired
frequency channel.
3. Release the button. After 4 seconds the display will stop flashing and the P2R
will automatically switch to the specified channel.
NOTE: Set the P2R to the same channel as the P2T TransMixer.

Wired Mode

When you are using the P2R Receiver as a stand-alone wired monitor, you can set the unit
to wired mode. This de-activates the RF circuitry and extends the battery life.
To Set the P2R to Wired Mode:
1. Press and hold the SELECT button until the CHANNEL LED indicator begins to flash.
2. When the LED indicator is flashing, press the SELECT button to scroll past channel 8 until the letter "A" appears in
the display.
3. Release the button. After 4 seconds the display will stop flashing and the P2R will automatically switch to wired mode.
NOTE: Setting the P2R receiver to wired mode disables its wireless capability.
CHANNEL LED Indicator
The CHANNEL LED indicator shuts itself off after 10 seconds to conserve battery life. To view the frequency channel when
the LED indicator is off, simply press and release the SELECT button.
To disable the battery saving feature:
1. Turn off the P2R.
2. Press and hold the SELECT button and turn the unit back on while holding down the button.
3. The LED indicator now displays the current frequency channel until you turn off the P2R and turn it back on.

MIX IN Jack

When you are using the P2R Receiver as a stand-alone personal monitor, the
serves as the primary audio input. In addition, the MIX IN jack allows the P2R to function as a hybrid
wired and wireless receiver. When you are using the P2R in its wireless mode, you can add a second
audio source via the MIX IN jack, such as.
S
Click Tracks
S
Pre-Amp Outputs from Guitar or Bass
Next to the jack is a two-position GAIN switch that gives you a choice between LO and HI gain settings
for the input. For specific information on how the MIX IN jack functions, refer to the wiring diagrams
on page 16.

LIM LED

The P2R Receiver has a non–defeatable (constantly active) limiter that automatically activates
if the receiver output level exceeds a certain volume, which is calibrated specifically for the
Shure E2 earphones. The LIM LED on the top of the unit lights up when the limiter is on. If the
LIM LED blinks occasionally, turn down the volume of the receiver.* If the LED is on and you
haven't reached a high enough listening level, try re-inserting the earphones for a better seal,
or adjust the mix that is being sent to the receiver to include only the most essential inputs.**
* When the LED is on, the volume will not increase.
ENGLISH
1
/ -inch MIX IN jack
4
S
Effects Processors
S
Condenser Microphones
** The limiter is designed to work best with the Shure E2 earphones.
Using the P2R with Shure E1 or E5, or earphones made by other
manufacturers, can result in higher limited volume levels.
8