Making Aconference Call - Radio Shack ET-598 Owner's Manual

43-698a.fm Page 19 Friday, August 13, 1999 12:56 PM
During the call, one of you can hang up
and the call can continue at the other
keypad.
Note: If you hear a high-pitched noise
from the base's speaker, the handset
and the base are too close together.
To talk with two parties using both out-
side lines, see "Making a Conference
Call."
MAKING A
CONFERENCE CALL
Follow these steps to make a 3-way
conference call.
1. Place the first call on hold.
2. Make or answer a call on the other
line.
Note: Be sure to wait until the
other party answers when you
make a call before proceeding to
Step 3. If you press
the other party answers, the call
might not be connected.
3. Press . The BATT LOW indi-
CONF
cator briefly flashes, then you can
talk with both parties.
To start a 4-way conference call (two
outside lines, handset, and speaker-
phone), first establish the 3-way con-
ference call, then press either line
button on the other keypad.
If you and someone else are already
talking to an outside line using both the
handset and speakerphone, the per-
son at the handset should place the
current call on hold, press the vacant
line button, then make the call. Then,
after the called party answers, press
INTERCOM
base presses
intercom, press
parties.
To end the conference call, press
TALK
or press
If you want to hang up one line and
continue talking on the other, press
HOLD
the line button for the line you want to
before
CONF hang up, then press the line button for
the line you want to keep.
. After the person at the
to answer the
SPEAKER
to join all four
CONF
, return the handset to the base,
on the base.
SPEAKER
to put both lines on hold, press
19