Setting The Dialing Mode - Radio Shack 2.4 GHz Digital Spread Spectrum Cordless Telephone with Call Waiting/Caller ID Owner's Manual

nector fits only one way), replace the
battery pack, and replace the cover.
To charge the battery pack, place the hand-
set on the base. The CHARGE indicator on
JejWb0&& JejWb0&& JejWb0&& JejWb0&&
the base lights and
Recharge the battery pack when
flashes on the display.
Notes:
• When you first use the phone after
charging or recharging the battery pack,
the phone might not work and you might
hear a beep when you press
Return the handset to the base for about
5 seconds to reset the security access-
protection code.
• If the handset or the base loses power,
the security access-protection code
might be lost. To reset the code, return
the handset to the base for about 5 sec-
onds.
• Using a pencil eraser, clean the charg-
ing contacts on the handset and base
about once a month.
• If the battery pack becomes weak during
a call, the handset beeps every 3 sec-
Bemý8Wjj[ho Bemý8Wjj[ho Bemý8Wjj[ho Bemý8Wjj[ho
onds and
• About once a month, fully discharge the
battery by keeping the handset off the
Bemý 8Wjj[ho Bemý 8Wjj[ho
Bemý 8Wjj[ho Bemý 8Wjj[ho
base until
wise, the battery pack loses its ability to
fully recharge.
• If the display is blank and the phone
does not work, recharge the battery
pack. (The battery power might be too
low to light the display.)
• If you are not going to use your phone
for an extended period of time, discon-
nect the battery pack. This increases the
battery pack's usable life.
8
The supplied battery pack should last about
a year. If the battery pack does not hold a
charge for more than 2 hours after an over-
night charge, replace it with a new 3.6-volt,
600 mAh battery pack with a connector that
appears.
fits the socket in the battery compartment.
You can order a replacement battery pack
Bemý8Wjj[ho Bemý8Wjj[ho Bemý8Wjj[ho Bemý8Wjj[ho
through your local RadioShack store. Install
the new battery pack and charge it for about
24 hours.
Warning: Dispose of the old battery pack
promptly and properly. Do not burn or bury it
(see "Battery Safety Instructions" on Page 4
for additional information on proper battery
.
TALK
handling).
SETTING THE DIALING
MODE
To set the dialing mode, set
the back of the base for the type of service
you have. If you are not sure which type you
have, do this test after you charge the hand-
set's battery pack.
flashes.
flashes. Other-
Installation
1. Set to
PULSE-TONE TONE
2. Lift the handset, press
for a dial tone.
3. Press any number other than
Note: If your telephone system requires
that you dial an access code (9, for
example) before you dial an outside
number, do not press the access code
number either.
If the dial tone stops , you have touch-
tone service. Leave
PULSE-TONE
.
TONE
If the dial tone continues , you have
pulse service. Set
.
PULSE
4. Press or place the handset on the
TALK
base to hang up.
on
PULSE-TONE
.
, and listen
TALK
.
0
set to
to
PULSE-TONE