Radio Shack ET-469 Owner's Manual page 6

43-469.fm Page 6 Tuesday, January 19, 1999 9:48 AM
If you have two separate one-line
modular jacks, plug one end of the
supplied two-line long modular cord
into and plug the sup-
L1 or L1/L2
plied one-line long modular cord into
.
L2
3. Insert the supplied AC adapter's
barrel plug into the
the back of the phone.
DC 9V
Caution: You must use a
!
Class 2 power source that
supplies 9 volts DC and
delivers at least 150 mA. Its center
tip must be set to negative and its
plug must fit the TAD-469's
jack. The supplied adapter meets
these specifications.
adapter that does not meet these
specifications could damage the
TAD-469 or the adapter.
6
4. Route the adapter's cord through
5. Insert the bracket's two small tabs
jack on
DC 9V
6. Connect the other end(s) of the
DC 9V
Using an
the strain relief slot on the back of
the phone.
Strain Relief Slot
into the matching slots at the upper
left on the bottom of the phone, and
snap the large tab of the bracket into
the large slot at the upper right.
phone cord(s) to the phone line
jack(s).