Procedure 7.1 - Replacing Or Removing A Rear Cover Section - Precor C532i Service Manual

Procedure 7.1 - Replacing or Removing a Rear Cover Section

Warning: Care must be taken when work is being performed in the area of the stairarms. Pinch
points exist between the stairarm and ramp and between the stairarm and crankarm,
when the rear covers are removed.
Procedure
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in Sec-
tion One, Things You Should Know.
1. This procedure details the removal and replacement of the entire rear cover assembly. It is
only necessary to perform the portion of this procedure that is required to access the
particular section or sections that you are servicing.
Removal
2. Reach inside one of the stairarm slots in the front portion of the rear cover and locate one of
the release points shown in Diagram 7.1. Gently, press upwards on the release point to
unsnap the access panel from the rear cover. Grasp the raised edge of the access panel
and remove it from the rear cover assembly.
Diagram 7.1 - Rear Cover Access Panel
3. Remove the two screws in the rear of the cover assembly and the mounting screw shown in
Diagram 7.2. Carefully pry the two snaps, shown in Diagram 7.2, toward the rear and
remove the top cover.
4. Remove the left and right covers from the cover assembly.
C532i, C556i Navy Elliptical Fitness Crosstrainer
Release
Point
Access
Panel
Page 35