Table of Contents
Advertisement
Procedure 7.8 - Replacing the Input Pulley Assembly
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in Sec-
tion One, Things You Should Know.
1.
Remove the left and right side rear covers per Procedure 7.1.
2.
Remove the stairarm assemblies as described in Procedure 7.14.
3.
Remove the crankarm assemblies as described in Procedure 7.5
4.
Remove the input pulley assembly mounting nuts (2 per pillow block bearing).
5.
Straighten the locking tabs and turn the left and right tension bolts counterclockwise until
tension is removed from the both belts. (Refer to Diagram 5.2)
Diagram 7.6 - Input Pulley Assembly
Pillow
Block
Bearing
Crankarm
6.
Remove the input pulley assembly. Slide input pulley belt off of the input pulley assembly.
7.
Hold the replacement input pulley assembly at it's mounting position and slide the input belt
over and past the pillow block bearing and onto the input pulley assembly.
8.
Replace the nuts on the pillow block bearings and torque them to 400 inch pounds.
C532i, C556i Navy Elliptical Fitness Crosstrainer
Input
Pulley
Assembly
Page 47
Advertisement
Table of Contents
Troubleshooting
