Connection Settings - SENDO X User Manual

3
send text messages, or select
line selection.
z Note:
Check with your service provider to find
out if this service is available.

Connection settings

The easiest way to automatically configure your
GPRS, WAP , Email and Internet connection settings is
to visit http://www.sendo.com/config. The Sendo
Easy Configurator sends an SMS message to your
phone containing the settings you require to start
using these services.
Check with your service provider to see if a data
connection has already been set up for you, and if
over-the-air (OTA) configuration is supported.
Access points
An access point is where your phone connects to the
Internet, via a data call (GSM) or a packet data
connection (GPRS).
There are three different types of access point that
you can define:
• MMS access point.
• Browser access point.
• Internet access point (IAP).
Check with the service provider which type of access
point is required for the service you wish to access.
Select Access points
to view a list of all current access points. If there are
Disable to prevent
from the Connection settings
no access points defined, you will be asked if you
want to create one.
!
To create a new access point
1. Press Options
2. Select Use default settings
settings, or Use existing settings
existing access point's settings as a starting
point.
3. Fill in all the required fields carefully with the
information obtained from your service
provider. Start at the top of the list and use the
down ; joypad key to scroll through the fields.
The fields that you must fill in will vary according
to the type of data connection you wish to make,
and the type of access point. Fill in all fields
marked with a red asterisk, or that are marked
Must be defined. The table below shows all
possible fields, with a brief explanation of each.
4. Once you have finished, press
the new access point settings and return to the
Access points list.
Select this To
Connection Give a descriptive name to the connection.
name
list
45
g and select
New access
to use the default
to use an
d to save
Back
Sendo X User Guide
point.