At^ssta Remote-Sat Activation - Siemens MC35 Terminal User Manual

Remote-SAT User's Guide
P R E L I M I N A R Y

1.2 AT^SSTA Remote-SAT Activation

Test command Response
AT^SSTA=? ^SSTA:(list of supported <state>s), (list of supported <alphabet>s)
Parameter description see below.
Read command
The read command can be used to request the current operating status and the
used alphabet of the Remote-SAT interface.
AT^SSTA?
State handling is described in chapter "States of ", pg. 9.
Response
^SSTA:<state>,<alphabet>,<allowedInstance>,<SatProfile>
<state>
*) Note:
Only this state can be selected directly by the TA, see write command.
<allowedInstance>
<SatProfile>
Write command The write command activates the AT command interface to the SIM Application
Toolkit in the ME. It must be issued each time the ME is switched on again.
AT^SSTA=
However, removing and inserting the SIM does not affect the activation status.
<mode>
[,<Alphabet>]
SAT commands which are not using the AT interface (non MMI related SAT
commands , e.g. PROVIDE LOCAL INFORMATION) may be executed without
activating Remote-SAT.
Response
OK
MC35_SAT_01_V01.01a - Preliminary
device is in one of the following state:
0 RESET
1 OFF
2 IDLE *)
3 PAC
4 WAIT
0 SAT is already used on an other instance (logical channel in
case of the multiplex protocol). Only test and read
commands can be used.
1 SAT may be started on this instance via the write version of
this command (see below).
SAT profile according to GSM 11.14, see appendix.
The profile tells the SIM application which features are supported
by the SIM Application Toolkit implemented by the ME. The profile
cannot be changed by the TA.
Page 19 of 64 15.11.2001