At^sstgi Remote-Sat Get Information - Setup Call (16) - Siemens MC35 Terminal User Manual

Remote-SAT User's Guide
P R E L I M I N A R Y
1.4.4 AT^SSTGI Remote-SAT Get Information – Setup Call (16)
Write command
This command is to be used upon receiving an unsolicited result code
^SSTN:16.
AT^SSTGI=16
If the SIM Application attempts to setup a call it uses this response to inform the
TA of the call´s parameters.
The sequence of events is as follows:
1. After the Remote-SAT notification 16 was issued the TA has to to ask for
2. If the SIM Application supplies no confirmation text or icon parameter, the
3. If the SIM Application supplies a non empty confirmation text or icon
4. If the user confirms to setup the call, AT^SSTR=16,0 shall be responsed.
5. If the user denies to setup the call, AT^SSTR=16,34 shall be responsed.
6. After confirmation phase the TA may show a dialling animation on the
7. If <TermQualifier> is not equal to 0 the dialling process did not perform
8. If <TermQualifier> is equal to 0, the dial process has been successfully
9. After this the TA shall show the call setup text and/or icon to the user, if
10. The TA shall give the user an opportunity to end an ongoing call, setup by
Response
^SSTGI:
Parameters
<cmdType>
<commandDetails>
<confirmationText>
<calledNumber>
<callSetupText>
<confirmationIconQualifier> Unsigned Integer, range 0 – 255, used as a bitfield.
MC35_SAT_01_V01.01a - Preliminary
the command parameter via AT^SSTGI=16.
TA gives other information to the user, e.g. the telephone number. In this
case flow continues at step 4.
parameter, the TA uses only these to ask the user whether he like to setup
the call or not.
screen until a mandatory URC ^SSTR: 16, <TermQualifier>,
<TerminationCauseText> is issued.
sucessfully.
If <TerminationCauseText> is not an empty string, this text has to be shown
to the user for an appropriate time, e.g. 2 seconds. The text contains
information regarding the dial termination cause, e.g. call barring through
Call Control by SIM mechanism.
<TerminationCauseText> is an empty string, the TA shall give an own
indication to the user.
finished.
supplied by the SIM. This information may be shown during the call.
the Proactive Command. In this case the TA shall issue an ATH command
to the ME.
<cmdType>, <commandDetails>, <confirmationText>,
<calledNumber>, <callSetupText>, <confirmationIconQualifier>,
<confirmationIconId>, <callSetupIconQualifier>,<callSetupIconId>
<CR> <LF>
16 – Proactive command ID, see Table 1
This byte is RFU.
String for user confirmation stage
String containing called number
String for call setup stage
bit 1:
Page 25 of 64
0 = icon is self explanatory and replaces text
1 = icon is not self-explanatory and shall be
displayed with the text
Determined value only if associated icon id is
not 0 (an icon exists).
15.11.2001