Using Call Breakthrough; Changing The Cbt Code; Changing The Remote Operation Security Code - Radio Shack TAD-739 Owner's Manual

43-739.fm Page 16 Friday, August 13, 1999 2:00 PM
USING CALL
BREAKTHROUGH
If you screen your calls but want to know
when calls come in from certain people,
give them your call breakthrough (CBT)
code.
When a caller enters the CBT code dur-
ing the outgoing message, the TAD
alerts you with a series of loud beeps for
35 seconds. To answer the call, pick up
the handset. If you do not answer, the
caller can leave a message after the
outgoing message plays.

Changing the CBT Code

The CBT code is preset to 648, but you
can change it by following these steps.
Note: Be sure to complete each step
within 8 seconds. Otherwise, the TAD
beeps four times and you must start
over from Step 1.
1. Hold down
CODE
beeps. (code) appears.
Co
2. Press .
REPEAT Cc
pears, and the TAD announces and
shows the current code's numbers
in sequence. Then the first digit of
the code reappears.
3. Repeatedly press
to set the first digit, then press
The second digit appears.
16
CHANGING THE REMOTE
OPERATION SECURITY
CODE
The remote operation security code is
preset to 739, but you can change it by
following these steps. Do not use the
same number you choose for the CBT
code.
Note: Be sure to complete each step
within 8 seconds. Otherwise, the TAD
beeps four times and you must start
over from Step 1.
until the TAD
(CBT code) ap-
or
SKIP REPEAT
.
STOP
4. Repeatedly press
to set the second and third digits,
pressing after each digit. The
STOP
TAD beeps and announces the new
CBT code.
1. Hold down
CODE
beeps. Co (code) appears.
2. Press again.
CODE
code) appears, and the TAD an-
nounces and displays the current
code's numbers (739) in sequence.
Then the first digit of the code ap-
pears.
3. Repeatedly press
to set the first digit, then press
The second digit appears.
4. Repeatedly press
to set the second and third digits,
pressing after each digit. The
STOP
TAD beeps and announces the new
remote operation security code.
or
SKIP REPEAT
until the TAD
Sc (security
or
SKIP REPEAT
.
STOP
SKIP or REPEAT