Checking The Outgoing Messages; Setting The Number Of Rings - Radio Shack TAD-739 Owner's Manual

43-739.fm Page 11 Friday, August 13, 1999 2:00 PM
1. To record the OGM 1 (or OGM 2)
message for each line, hold down
(or
OGM 1 OGM 2
beeps and both ANSWER indicators
flash.
Notes:
• Proceed next step within 8 seconds.
Otherwise, the TAD sounds a short
beep, and you must start again from
Step 1.
• Recording OGM 2 only does not
turn on the TAD. You must start re-
cording OGM from OGM 1.
2. Press
ANSWER
or
LINE 1 LINE 2
message from about 8 inches from
the front of the TAD.
3. When you finish, press
TAD beeps and plays back the out-
going message.
Note: When you finish recording
OGM 1 only, the TAD automatically
sets to answer on. The ANSWER in-
dicator above
LINE 1
Checking the Outgoing
Messages
To check an outgoing message, press
its button ( or
OGM 1
the announcement number
the TAD beeps and both ANSWER indi-
) until the TAD
above the desired
, and speak your
. The
STOP
lights.
). You see
OGM 2
A1 or A2 ,
cators flash. Then press
8 seconds on the selected line and the
message plays after the beep.
If there is no announcement recorded,
you hear "You have no announcement
one (or "two") in line one (or "two")"
when you press its button.
SETTING THE NUMBER
OF RINGS
Set each line's ring select switch to
, or to set how long the TAD waits
7 TS
before it answers a call (2 rings, 4 rings,
7 rings or toll-saver).
If you plan to check your messages by
long distance, set the ring select switch
to (see "Using the Toll-Saver" on
TS
Page 17).
within
ANSWER
, ,
2 4
11