Using Call Breakthrough; Changing The Remote Operation Security Code - Radio Shack TAD-704 Owner's Manual

43-704.fm Page 14 Wednesday, November 17, 1999 4:47 PM
Listen to the caller's message through
the TAD's speaker. To adjust the vol-
ume, slide on the right side of
VOLUME
the TAD.
If you decide to answer the call, pick up
any phone on the same phone line as
the TAD. The TAD stops recording and
resets to answer the next call.
If you do not want to take the call, simply
let the TAD finish recording the caller's
message.
Note: If you answer the phone just as
the TAD answers, the TAD might not
stop playing the outgoing message. If
this happens, press
STOP
USING CALL
BREAKTHROUGH
If you screen your calls but want to know
when calls come in from certain people,
give them your Call Breakthrough (CBT)
Code.
When a caller enters the CBT code dur-
ing the outgoing message, the TAD
alerts you with a series of loud beeps for
35 seconds. To answer the call, pick up
the handset. If you do not answer, the
caller can leave a message after the
outgoing message plays.
14
Changing the CBT Code
The CBT code is preset to 168, but you
can change it by following these steps.
Note: If you do not complete each step
within 8 seconds, the TAD exits setup.
Start again from Step 1.
1. Hold down
2. Press
3. Repeatedly press
on the TAD.
4. Repeat Step 3 to set the second and
5. Press
CHANGING THE REMOTE
OPERATION SECURITY
CODE
The TAD's remote operation security
code is preset to 704, but you can
change it by following these steps.
Note: If you do not complete each step
within 8 seconds, the TAD exits setup.
Start again from Step 1.
until the TAD
STOP
beeps once.
four times. 168
CALLBACK
and
SET CBT CODE
flashes.
REPEAT
first digit, then press
SKIP
ond digit flashes.
Note: If you make a mistake,
repeatedly press
SKIP
desired digit flashes then re-enter
the code.
the third digits.
then press
CALLBACK
to return to the time display.
appear.
1
to set the
. The sec-
until the
STOP