To Turn A Channel On Or Off - Agilent Technologies 54831A User's Quick Start Manual

Using the Oscilloscope

To turn a channel on or off

To turn a channel on or off
• To turn a channel on, click the check box next to the channel number
so that a check mark appears in the box. To turn a channel off, click
the check box again to clear it.
See figure 3-30.
If you are not using a channel, you can turn it off. This simplifies the waveform
display and also increases the display update rate. When you turn off a channel,
the current vertical scaling factor and vertical scale buttons for that channel
disappear. They re-appear when you turn the channel on.
You can also turn a channel on or off by using the Channel Setup dialog box, or
by using the front panel key for that channel.
Figure 3-30
Turn a channel on by
clicking in the On
check box until a
check mark appears
Turning a Channel On or Off
3-40
Turn a channel off
by clicking in the
On check box until
the box is cleared