Launch Cable Parameters - JDS Uniphase 4100 User Manual

Auto
No
If the option OptiPulse is available, see
tion with OptiPulses mode" on page 68
tion with this option.
Otdr Connector test
This parameter allows to choose if a test of the front connector must be
performed when acquisition is launched.
No
Yes & Continue the OTDR connection is tested, and if the state is not
Yes & Abort
Launch Cable End / Receive Cable Start
Launch cable
parameters
No
Evt 1, 2, 3
Distance
Include Link Start Connector / Include Link End Connector
Defining the Launch Cable End parameter with an event number or a
distance will automatically activate the corresponding parameter Include
Link Start Connector. This parameters can be set to Yes if the budget
must include the connectors loss of the launch cable at end
Defining the Receive Cable Start parameter with an event number or a
distance, will automatically activate the corresponding parameter
Include Link End Connector. This parameters can be set to Yes if the
budget must include the connectors loss of the launch cable at start
If those parameters are set to No, the budget only displays the connector
loss of the fiber.
User Manual
Chapter 4 Configuring the reflectometry test
a first short acquisition is performed with the shortest
pulse in the range, before the standard one.
the standard acquisition is directly launched.
the OTDR connection is tested with indication Bad/
Good.
good, the acquisition continues but a warning
displays.
the OTDR connection is tested, and if the state is
bad, a warning displays and the acquisition stops.
All the results are displayed and referenced on the
basis of the board of the module.
The results relating to the launch cable are eliminated
from the table. Attenuation and distances are then
measured on the basis of the marker Evt 1, 2 or 3
selected.
Edit Number
Use the
/ Max=50 km / 164.042 kfeet / 31.075 miles) or affect
the active cursor value, using the
Distance
key.
770000102/08
Configuring the test in OTDR Expert
"Configuring the OTDR acquisi-
to configure the OTDR acquisi-
key to enter a distance (Min= 0
Set Cursor
23