HEIDENHAIN MANUALplus 620 Manual page 17

Options The capabilities of the MANUALplus 620 can also be adapted
retroactively with options to meet new requirements. These
options are described on page 14. They are enabled by entering
keywords based on the SIK number, and are saved in the SIK
component. Please indicate your SIK number when ordering new
options.
Memory medium The storage medium is a CFR (= CompactFlash Removable)
compact flash memory card. It contains the NC software and
is used to store NC and PLC programs. The storage medium
is removable and must be ordered separately from the main
computer.
Please note: These CFRs use the fast SATA protocol (CFast) for
significantly shorter access times. They are not compatible with
the previous CFRs and can be used only in conjunction with the
MC 7410 T main computer.
CFR CompactFlash 8 GB
Free capacity for NC programs
Free capacity for PLC programs
No export license required
SIK component The SIK component contains the NC software license for
enabling control loops and software options. It gives the main
computer an unambiguous ID code—the SIK number. The SIK
component is ordered and shipped separately. It must be inserted
in a special slot in the MC main computer.
The SIK component with the NC software license is available in
various versions, depending on the enabled control loops and
options. Further control loops can be enabled later by entering a
keyword. HEIDENHAIN provides the keyword, which is based on
the SIK number.
When ordering, please indicate the SIK number of your control.
When the keywords are entered in the control, they are saved
in the SIK component. This enables and activates the options.
Should service become necessary, the SIK component must be
inserted in the replacement control to enable all required options.
Master keyword For commissioning the MANUALplus 620, a general key can
(General Key) be used that will unlock all control loop options for a duration of
90 days. After this period, only those options with the correct
keywords will be active. The general key is activated via a soft key.
TNCkeygen TNCkeygen is a collection of PC software tools for generating
(accessory) time-limited enabling keys for HEIDENHAIN controls.
OEM Key Generator is used to generate enabling keys for
software options by entering the SIK number, the option to be
enabled, the duration and a manufacturer-specific password. The
enabling period is limited to 10 to 90 days. Each option can only be
enabled once. Option enabling is independent of the general key.
The OEM daily key generator generates an enabling key for the
protected area of the machine tool builder. This grants the operator
access to the area on the day the key was generated.
CFR CompactFlash
1.8 GB
350 MB
ID 1075055-54
SIK component
17