HEIDENHAIN MANUALplus 620 Manual page 10

User functions
User function
✓
Short description
✓
Operating modes
✓
Manual Operation
✓
Teach-In mode
Program Run
✓
✓
Setup functions
✓
✓
✓
✓
✓
Programming
Cycle Programming
10
MANUALplus 620
Basic version: X and Z axis, spindle
0-6 Driven tool and auxiliary axes (U, V, W)
55+0-6 C axis and driven tool
70+0-6 Y axis
54+0-6 B axis
94+0-6 Parallel axes U, V, W (display function and compensation)
132+0-6 Counter spindle
Digital current and shaft speed control
Manual slide movement through axis-direction keys, intermediate switch or electronic
handwheels
Graphic support for entering and running cycles without saving the machining steps in
alternation with manual machine operation
11 Thread reworking (thread repair in a second workpiece setup)
8 Sequential linking of fixed cycles, where each cycle is run immediately after input, or is
graphically simulated and subsequently saved
All are possible in single-block and full-sequence modes
DIN PLUS programs
9 smart.Turn programs
8 Cycle programs
Workpiece datum setting
Definition of tool-change position
Definition of protection zone
Defining machine dimensions
Manual programs
Tool measurement by touching the workpiece
17 Tool measurement with a TT tool touch probe
17 Tool measurement with an optical gauge
17 Workpiece measurement with a TS workpiece touch probe
8 Turning cycles for simple and complex contours, and contours described with ICP
8 Contour-parallel turning cycles
8 Recessing cycles for simple or complex contours, as well as contours defined with ICP
8 Repetitions with recessing cycles
8 Recess turning cycles for simple and complex contours, and contours described with ICP
8 Undercut and parting cycles
8 Engraving cycles
8 Threading cycles for single or multi-start longitudinal, taper or API threads, threads with variable
pitch
8+55 Cycles for axial and radial drilling, pecking and tapping operations with the C axis
8+55 Thread milling with the C axis
8+55 Axial and radial milling cycles for slots, figures, single surfaces and polygons as well as for
complex contours defined with ICP for machining with the C axis
8+55 Helical slot milling (multi-start) with the C axis
8+55 Deburring of ICP contours
8+55 Linear and circular patterns for drilling, boring and milling operations with the C axis
8 Context-sensitive help graphics
8 Transfer of cutting values from technology database
8 Use of DIN macros in cycle programs
8+9 Conversion of cycle programs to smart.Turn programs