Maintenance And Storage - Omron MIT Elite Plus Instruction Manual

HEM-7301-ITKE_main.book Page 36 Friday, October 3, 2008 12:42 PM

7.Maintenance and Storage

7. Maintenance and Storage
Maintenance
To protect your unit from damage, please observe the following:
• Do not subject the main unit and cuff to extreme temperatures,
humidity, moisture or direct sunlight.
• Do not fold the cuff or tubing tightly.
• Do not inflate the arm cuff over 299 mmHg.
• Do not disassemble the unit.
• Do not subject the unit to strong shocks or vibrations (for example,
dropping the unit on the floor).
• Do not use volatile liquids to clean the main unit. The unit should be
cleaned with a soft, dry cloth.
• Do not wash the arm cuff or immerse it in water.
• Do not use petrol, thinners or similar solvents to clean the arm cuff.
• Use a soft, moistened cloth and soap to clean the arm cuff.
• Do not carry out repairs of any kind by yourself. If a defect occurs,
consult your OMRON retail outlet or distributor as mentioned on the
packaging.
Calibration and Service
• The accuracy of this blood pressure monitor has been carefully tested
and is designed for a long service life.
• It is generally recommended to have the unit inspected every two
years to ensure correct functioning and accuracy. Please consult your
authorised OMRON dealer or the OMRON Customer Service at the
address given on the packaging or attached literature.
Note: Inspections are normally not covered by guarantee, please
check the included guarantee card.
36