Advertisement
units into a cradle that has the AC adapter power plug con-
nected. Plug the other end of the AC adapter into a wall out-
let.
2. The battery in the expansion pack begins to charge only
after the battery in the iPAQ is fully charged. The iPAQ bat-
tery takes approximately 2.5 hours to charge when fully dis-
charged.
3. Check the state of the expansion pack battery on the "Power"
screen under the "External battery:" entry.
4. When expansion pack, when being charged, will have "Re-
charging" state: and "Charging state" displays above the bar
graph on the iPAQ charging screen.
Note:
The bar graph continuously steps from 0 to 100% as
the battery is charging.
5. When the expansion pack battery is completely charged, the
entry above the bar graph will change to read "Battery power
remaining:" and the bar graph will be filled to 100%.
6. When the expansion pack battery is completely charged, re-
move the external power from the AC adapter.
Note:
The battery in the expansion pack begins to charge
only after the battery in the iPAQ fully charged. The
iPAQ battery and the external battery together take ap-
proximately 5 hours to charge when both are fully dis-
charged.
Inserting the iPAQ into the SPS 3000
1. Slide the iPAQ through the SPS 3000 sleeves to connect the
iPAQ and SPS 3000.
S P S
S C A N / L A N
3 0 0 0
8
Advertisement
